
B5 Robotic controller does respond on command Reset the unit and retry
operation. After several
occurrences contact technical
support
C0 Network initialization failed Check network cable and
network configuration. If the
error recurs, contact
technical support
C1 Telnet Interface initialization failed Check network cable and
network configuration. If the
error recurs, contact
technical support
C2 Webserver initialization failed Check network cable and
network configuration. If the
error recurs, contact
technical support
C6 Ping command did not reached target Check network cable and
network configuration. If the
error recurs, contact
technical support
C7 Cannot Upgrade from USB Retry of Firmware upgrade, if
not successful contact
technical support
D0 ROM error.
ROM checksum incorrect
Retry of Firmware upgrade, if
not successful contact
technical support
D1 RAM error.
Power on Self Test ( POST ) has failed,
Retry operation; after several
occurrences contact technical
support
D2 NVRAM error.
R/W operation to NVRAM has failed
Retry operation; after several
occurrences contact technical
support
D5 Display Error
Communication to display failed
Retry operation; after several
occurrences contact technical
support
D7 Fatal system error Retry operation; after several
occurrences contact technical
support
D8 Data base error Retry operation; after several
occurrences contact technical
support
D9 No SCSI IC detected Retry operation; after several
occurrences contact technical
support
DA In Wellness Test the barcode reader has read
different barcode data for the same cartridge label
Check barcode label on
scratch cartridge and run
‘Library Health Check’again.
If the error recurs, contact
technical support
Kommentare zu diesen Handbüchern