Dell PowerVault TL4000 Betriebsanleitung PDF herunterladen (Seite 21)

Rackmounting the library

The library easily installs into a standard 19” rack system taking up 4U of space.

WARNING!

The AP Series tape library weighs 24.5 kg without media.

To reduce the risk of personal injury or damage to the library:

1) observe local health and safety requirements and guidelines for manual material handling,

2) obtain adequate assistance to lift and stabilize the library during installation or removal,

3) always remove all tapes to reduce the overall weight of the library.

Required tools:

1. #3 Phillips screwdriver

2. T10 Torx screwdriver (included in you shipment)

There are two sets of eight M6 screws in the accessory package that came with your library. The type of

rack that you have will determine the type of M6 screw that you will use.

To install the library:

3. Determine the location in you rack for your library to be installed and, using a pencil, mark the

location on each vertical rail in you rack.

4. Using the screws for your rack type, and a #3 Phillips screwdriver, secure one rail to each side

of the rack in your chosen rack location. Secure both the front and back of each rail to the

rack. The rails extend to fit a variety of rack depths. The correct orientation of the left and

right rails is shown in Figure 9.

Figure 9 Installing the rails into the rack

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 79 80

Keine Kommentare

Dell PowerVault TL4000 Betriebsanleitung Seite 21