Dell PowerVault TL4000 Betriebsanleitung PDF herunterladen (Seite 55)

Figure 53 Tape drive removal

CAUTION:

Push in on the tape drive handle while supporting the bottom of the tape drive until it is

properly seated. Damage to the connector pins may occur if this procedure is not followed.

To replace a tape drive:

1. Before installing the new drive, inspect the connectors on the tape drive. Ensure that the

connectors are intact, free of any foreign objects, and have no cracks or deformed or bent

contacts.

2. Slowly insert the new tape drive into the drive bay, and align the connectors on the library

while supporting the drive assembly (see Figure 54).

Figure 54 Installing a tape drive

3. Push the tape drive slowly into the drive bay until the drive seats itself against the back of the

library.

NOTE: If you are adding an additional tape drive to your library, or if you are upgrading an existing

drive, be sure to use supported cabling configurations.

4. Push the Product ID Foil back underneath the drive sled. When inserted properly, only the

handle of the Foil will be visible.

5. Tighten the captive thumbscrews until the drive is secure.

6. Connecting the power cable, SCSI cable and terminator.

7. Power on the library(or power on the drive refer to “Changing the drive configuration” on page

45) using the power button on the front panel.

8. Run the Library Verify test.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 79 80

Keine Kommentare

Dell PowerVault TL4000 Betriebsanleitung Seite 55