Dell PowerVault TL4000 Betriebsanleitung PDF herunterladen (Seite 54)

8.3 Removing and replacing a tape drive

Tape drives are installed at the back of the library.

When replacing one drive in a two drive configuration, you can power down the drive that you are

replacing without interrupting power to the rest of the library and the second drive. Refer to “Changing

the drive configuration” on page

45.

NOTE:

This part is hot pluggable. It is not mandatory to power down the library to replace a drive.

To remove a tape drive:

1. Using your Remote Management Unit or the Operator Control Panel, unload the tape cartridge(s)

from the drive to be removed.

Figure 52 Drive sled components of rear panel

2. Power down the library using the power button on the front panel (see Figure 52 detail 1).

3. The LED on the tape drive being removed is off (Figure 52 detail 2).

4. Remove the power cable, SCSI cable and terminator, if applicable from the tape drive being removed

(see Figure 52 details 3, 4 and 5).

5. Loosen the captive thumbscrews on the drive (Figure 52 detail 6).

IMPORTANT: Before pulling the lower drive sled please pull forward the product ID slide located below

the drive sled (see figure 53 detail 1). Otherwise the slide or the attached label could be

damaged.

Pull straight back on the tape drive handle to remove it from the library. Take care to slightly push

down the product ID slide so it does not interfere with the drive sled (see figure 53

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 79 80

Keine Kommentare

Dell PowerVault TL4000 Betriebsanleitung Seite 54