Dell IDRAC6 Betriebsanweisung PDF herunterladen (Seite 49)

Configuring the iDRAC6 Using the Web Interface 49

Configuring the iDRAC6 NIC

This section assumes that the iDRAC6 has already been configured and is

accessible on the network. See "Configuring iDRAC6" on page 36 for help

with the initial iDRAC6 network configuration.

Configuring the Network and IPMI LAN Settings

NOTE: You must have Configure iDRAC permission to perform the following steps.

NOTE: Most DHCP servers require a server to store a client identifier token in its

reservations table. The client (iDRAC, for example) must provide this token during

DHCP negotiation. The iDRAC6 supplies the client identifier option using a one-byte

interface number (0) followed by a six-byte MAC address.

NOTE: If you are running with Spanning Tree Protocol (STP) enabled, ensure that

you also have PortFast or a similar technology turned on as follows:

- On the ports for the switch connected to iDRAC6

- On the ports connected to the management station running an iDRAC Virtual

Console session

NOTE: You may see the following message if the system halts during POST: Strike

the F1 key to continue, F2 to run the system setup program

One possible reason for the error is a network storm event, which causes you to lose

communication with the iDRAC6. After the network storm subsides, restart the system.

Click

iDRAC Settings



Network/Security



Network.

On the

Network

page, you can enter Network settings, Common iDRAC6

settings, IPv4 settings, IPv6 settings, IPMI settings, and VLAN settings.

Se e Ta ble 4-2 , Ta bl e 4 - 3 , Ta bl e 4- 4 , Ta b l e 4 - 5 ,

Table 4-6, and Table 4-7 for descriptions of these settings.

After entering the required settings, click

Apply

The new settings made to the Network page are saved.

Table 4-1. User Privilege Behavior in Supported Browsers

Browser Tab Behavior Window Behavior

Microsoft Internet

Explorer 6

Not applicable New session

Microsoft IE7 and IE8 From latest session opened New session

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 371 372

Keine Kommentare

Dell IDRAC6 Betriebsanweisung Seite 49