Dell IDRAC6 Betriebsanweisung PDF herunterladen (Seite 102)

102 Advanced iDRAC6 Configuration

Configuring the Management Station Terminal

Emulation Software

iDRAC6 supports a serial or Telnet text console from a management station

running one of the following types of terminal emulation software:

• Linux Minicom in an Xterm

• Hilgraeve’s HyperTerminal Private Edition (version 6.3)

• Linux Telnet in an Xterm

•Microsoft Telnet

Perform the steps in the following subsections to configure your type of terminal

software. If you are using Microsoft Telnet, configuration is not required.

Configuring Linux Minicom for Serial Console Emulation

Minicom is the serial port access utility for Linux. The following steps are

valid for configuring Minicom version 2.0. Other Minicom versions may differ

slightly but require the same basic settings. Use the information in "Required

Minicom Settings for Serial Console Emulation" on page 104 to configure

other versions of Minicom.

Configuring Minicom Version 2.0 for Serial Console Emulation

NOTE: To ensure that the text displays properly, it is recommended that you use an

Xterm window to display the Telnet console instead of the default console provided

by the Linux installation.

To start a new Xterm session, type

xterm &

at the command prompt.

In the Xterm window, move your mouse arrow to the lower right-hand

corner of the window and resize the window to 80 x 25.

CTS (Clear To Send) 8 7

SG (Signal Ground) 5 5

DSR (Data Set Ready) 6 4

CD (Carrier Detect) 1 4

DTR (Data Terminal Ready) 4 1 and 6

Table 5-5. Required Pinout for DB-9 Null Modem Cable

(continued)

Signal Name DB-9 Pin (server pin) DB-9 Pin (workstation pin)

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 371 372

Keine Kommentare

Dell IDRAC6 Betriebsanweisung Seite 102