Dell IDRAC6 Betriebsanweisung PDF herunterladen (Seite 167)

Using the iDRAC6 Directory Service 167

NOTE: The Bit Mask values are used only when setting Standard Schema

using RACADM.

Single Domain Versus Multiple Domain Scenarios

If all the login users and role groups, and the nested groups, are in the same

domain, then only the domain controllers’ addresses must be configured on

iDRAC6. In this single domain scenario, any group type is supported.

If all the login users and role groups, or any of the nested groups, are from

multiple domains, then Global Catalog server addresses are required to be

configured on iDRAC6. In this multiple domain scenario, all the role groups

and the nested groups, if any, must be a Universal Group type.

Configuring Standard Schema Microsoft Active

Directory to Access iDRAC6

You must perform the following steps to configure Active Directory before an

Active Directory user can access iDRAC6:

On an Active Directory server (domain controller), open the

Active

Directory Users and Computers Snap-in.

Create a group or select an existing group. Add the Active Directory user

as a member of the Active Directory group to access the iDRAC6.

Table 7-9. Default Role Group Privileges

Privilege Level Permissions Granted Bit Mask

Administrator Login to iDRAC, Configure iDRAC,

Configure Users, Clear Logs, Execute Server

Control Commands, Access Virtual

Console, Access Virtual Media, Test Alerts,

Execute Diagnostic Commands

0x000001ff

Operator Login to iDRAC, Configure iDRAC,

Execute Server Control Commands, Access

Virtual Console, Access Virtual Media, Test

Alerts, Execute Diagnostic Commands

0x000000f9

Read Only Login to iDRAC 0x00000001

None No assigned permissions 0x00000000

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 371 372

Keine Kommentare

Dell IDRAC6 Betriebsanweisung Seite 167