Dell IDRAC6 Betriebsanweisung PDF herunterladen (Seite 39)

Basic Installation of the iDRAC6 39

Updating the iDRAC6 Firmware

Use one of the following methods to update your iDRAC6 firmware.

• Web-based Interface (see "Updating the iDRAC6 Firmware Using the

Web-Based Interface" on page 40)

• RACADM CLI (see "Updating the iDRAC6 Firmware Using RACADM"

on page 40)

• Dell Update Packages (see "Updating the iDRAC6 Firmware Using Dell

Update Packages for Supported Windows and Linux Operating Systems"

on page 41)

Before You Begin

Before you update your iDRAC6 firmware using local RACADM or the

Dell Update Packages, perform the following procedures. Otherwise, the

firmware update operation may fail.

Install and enable the appropriate IPMI and managed node drivers.

If your system is running a Windows operating system, enable and start

the

Windows Management Instrumentation

(WMI) service.

If you are using iDRAC6 Enterprise and your system is running SUSE Linux

Enterprise Server (version 10) for Intel EM64T, start the

Raw

service.

Disconnect and unmount Virtual Media.

NOTE: If iDRAC6 firmware update is interrupted for any reason, a wait of up to

30 minutes may be required before a firmware update will be allowed again.

Ensure that the USB is enabled.

Downloading the iDRAC6 Firmware

To update your iDRAC6 firmware, download the latest firmware from the

Dell Support website located at support.dell.com and save the file to your

local system.

The following software components are included with your iDRAC6 firmware

package:

• Compiled iDRAC6 firmware code and data

• Web-based interface, JPEG, and other user interface data files

• Default configuration files

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 371 372

Keine Kommentare

Dell IDRAC6 Betriebsanweisung Seite 39