Dell Active Fabric Manager Betriebsanweisung PDF herunterladen (Seite 86)

Figure 35. Layer 2 VLT Uplink Configuration

To configure the uplink protocol for the edge port uplinks to the WAN:

1. Navigate to the Network >

Fabric Name

> Configure and Deploy screen.

2. From the Deploy Fabric pull-down menu, select the Pre-deployment Configuration option.

3. Navigate to the Uplink Configuration screen.

4. In the Protocol Settings, select a routing protocol (OSPF, IBGP, or eBGP) for the edge port uplinks. The Bandwidth

and Port Count screen specifies the number of uplinks.

The range of IP addresses belong to the /30 subnet is automatically populated by the AFM.

– For OSPF, for each specified uplink, enter the local IP address, remote neighbor IP address, and area ID. A

valid area ID area is 0 to 65535.

– For iBGP, for each specified uplink, enter the local IP address, remote neighbor IP address, local AS number.

For the AS number, enter a value from 1 to 4294967295.

– For eBGP, for each specified uplink, enter the local IP, remote neighbor IP address, local AS number, and

remote AS number. For the AS number, enter a value from 1 to 4294967295.

5. In the Loopback IP Address Range/Prefix, enter the loopback IP address and prefx.

6. Click Next to go the VLT VLAN Configuration screen.

Pre-deployment - Step 1b: VLT VLAN Configuration

To specify a VLT VLAN to be applied to the Layer 2 fabric manually or automatically, use this screen. Specify at least one

VLAN configuration.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 178 179

Keine Kommentare

Dell Active Fabric Manager Betriebsanweisung Seite 86