Dell TL2000 Bedienungsanleitung Seite 84
- Seite / 264
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Inserting the Cleaning Cartridge
See the Note below for 4U libraries with a Dedicated Cleaning Slot (DCS).
The following criteria must be followed for Auto Clean to function:
1. The Auto Clean function must be configured ″On″ or ″Enabled″.
v Operator Control Panel: Configure->Library Settings->Enabled
v Web User Interface: Configure Library->General->Auto Clean->checkmark
Note:
Earlier versions of the 4U library contained a Dedicated Cleaning Slot
(DCS). This DCS can be retained and is supported by future library
firmware updates. However, library firmware later than 3.90 will allow
removal of the DCS, thus enabling this slot to be used as a storage
slot. Once the DCS is removed, the Auto Clean cleaning cartridge slot
must be configured as described below. If the DCS has been removed,
it can only be reinstated by restoring factory default settings. To
remove the DCS, perform the following procedure using the Operator
Control Panel (OCP): OCP->Configure->Library Settings->General-
>Remove
DCS->No/Yes->Save.
2. A storage slot must be reserved (Res or RSVD).
v Reserving a slot is accomplished by reducing the Active Slot count in any
particular logical library. A reserved slot (or slots) is always the last slot in
the last magazine of any particular logical library. A cleaning cartridge that is
in a reserved slot is available to any logical library drive even if the reserved
slot is not in that particular logical library. If the library contains multiple
logical libraries, typically, the last logical library is chosen to be the reserved
slot containing the cleaning cartridge. As with a library with a single logical
library, this slot is the last physical slot in the library (top right magazine,
uppermost rear slot).
3. A cleaning cartridge (CLNxxxLx) must be placed or moved to a reserved slot.
v A cleaning cartridge must be replaced after 50 uses. Click on the Web User
Interface, Monitor Library->Inventory .
v Find the magazine that contains the cleaning cartridge.
v Click on the (+) located under that magazine presentation to expand the
detail of resident cartridges.
v Observe the cleaning cartridge location displayed. The number of Media
Loads represent how many times the cleaning cartridge has been used. The
number 50, minus that Media Load number represents the number of uses
left.
4.
To install a cleaning cartridge in the 2U or 4U library:
a. Use the Operator Control Panel: Control → Move Cartridge or the Web User
Interface: Manage Library → Move Media to insert the cleaning cartridge
into the reserved slot or the DCS (if one exists, 4U only).
b. An alternate method is to use the Release Magazine option:
v Operator Control Panel: Control → Magazine (Left/Right)
v Web User Interface: Manage Library → Release Magazines (Left/Right)
c.
Place a cleaning cartridge into the reserved slot or the DCS (if one exists, 4U
only).
Note:
A user has the option to perform manual cleaning by navigating in the
RMU to Service → Clean Drive. In units with more than one drive to be
4-34 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide
- User’s Guide 1
- Read this First 5
- Contents 7
- Figures 9
- Danger Notice 13
- Caution Notice 13
- Class I Laser Product 14
- Rack Safety 15
- Preface 17
- Front Panel 19
- Rear Panel 21
- Internal View of Library 23
- Bar Code Reader 24
- Encryption 24
- SNMP Messaging 26
- Ultrium Tape Drives 27
- Speed Matching 28
- Channel Calibration 28
- Power Management 29
- Library Specifications 29
- Operation Specifications 30
- Environmental Specifications 30
- Product Environment 31
- Supported Device Drivers 31
- Operator Control Panel 33
- Power-ON Display 34
- Input Modes 35
- Power ON/OFF 36
- Web User Interface 36
- System Status 38
- Basic Guidelines 41
- Library Sharing 41
- Host Interfaces 46
- SCSI Interface 46
- Using Multiple SCSI Buses 47
- SAS Interface 48
- Fibre Channel Interface 48
- Cables and Speeds 49
- Installing Your Library 51
- Choosing a Location 51
- Unpacking the Library 52
- Verifying the Shipment 52
- 2. Store the lock ( 55
- ) and label ( 55
- Figure 4-5 on page 4-6 55
- Connecting a Power Cord 63
- Configuring Your Library 64
- Verifying/Updating Firmware 67
- Setting Up Encryption 71
- Interface 77
- Configuration 78
- Preparing the Host 79
- Verifying the Connection 79
- Cartridge Magazines 80
- 2U Library I/O Station 81
- 4U Library I/O Station 82
- Chapter 5. Operations 87
- Chapter 5. Operations 5-3 89
- Chapter 5. Operations 5-5 91
- Chapter 5. Operations 5-7 93
- Chapter 5. Operations 5-9 95
- Monitor Menu 97
- Monitor: Drive 99
- Monitor: Inventory 101
- Control Menu 102
- Control: Move Cartridges 103
- Control: Magazine 103
- Configure Menu 104
- Chapter 5. Operations 5-19 105
- Configure: Library 106
- Chapter 5. Operations 5-21 107
- Configure: Drive 108
- Configure: Network 109
- Configure: Set Access PIN 110
- Chapter 5. Operations 5-25 111
- Service Menu 112
- Service: Run Tests 113
- Service: Service (Drives) 113
- Drive Tests 114
- Clean Drive 114
- Drive Power 114
- Web User Interface Menus 115
- Monitor Library Menu 116
- Chapter 5. Operations 5-31 117
- Chapter 5. Operations 5-33 119
- Chapter 5. Operations 5-35 121
- Drive Inventory 123
- Magazine Inventory 123
- Configure Library Menu 124
- Chapter 5. Operations 5-39 125
- Chapter 5. Operations 5-41 127
- Configure Library: Drives 129
- Configure Library: Network 130
- Chapter 5. Operations 5-45 131
- Chapter 5. Operations 5-47 133
- Manage Library Menu 135
- Service Library Menu 136
- View Logs 137
- View Drive Logs 137
- Save Drive Dump 138
- Chapter 5. Operations 5-53 139
- Service Library: Reboot 141
- Import Media 141
- Export Media 142
- Dedicated Cleaning Slot 143
- Reserving Slots 143
- Data Cartridges 145
- Cartridge Compatibility 146
- WORM Media 147
- WORM Media Errors 147
- Cleaning Cartridge 147
- Bar Code Label 148
- Write-Protect Switch 149
- Handling the Cartridges 150
- Provide Training 150
- Ensure Proper Packaging 150
- Chapter 7. Troubleshooting 155
- Maintenance Problems 156
- Problem 165
- Chapter 8. Error Codes 169
- Tools Required 187
- Electrostatic Discharge 187
- Relocating Your Library 187
- 1 SCSI cable 190
- 2U Library 4U Library 193
- Swapping Power Supplies 208
- Enclosure 211
- Mixing of Drives 215
- SCSI Element Addressing 217
- Appendix C. Sense Data 225
- 30h 07h Cleaning failure 226
- Drive Sense Data 230
- Red Hat Enterprise Linux 240
- 2003/XP and 2008/Vista 243
- Windows 2008/Vista 244
- Notices 247
- Glossary 249
- Numbers 249
- Glossary H-3 251
- Glossary H-5 253
- Glossary H-7 255
- Glossary H-9 257
- Printed in USA 264
Verwandte Produkte und Handbücher für Computerzubehör Dell TL2000
Computerzubehör Dell 5316M Bedienungsanleitung
(15 Seiten)
(15 Seiten)
(268 Seiten)
(330 Seiten)
(32 Seiten)
(178 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.423 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern