Dell TL2000 Bedienungsanleitung PDF herunterladen (Seite 221)

TapeAlert Flags Supported by the Drive

Table B-1. TapeAlert Flags Supported by the Ultrium Tape Drive

Flag

Number Flag Description Action Required

3 Hard error Set for any unrecoverable read, write,

or positioning error. (This flag is set in

conjunction with flags 4, 5, or 6.)

See the Action Required column for

Flag Number 4, 5, or 6 in this table.

4 Media Set for any unrecoverable read, write,

or positioning error that is due to a

faulty tape cartridge.

Replace the tape cartridge.

5 Read failure Set for any unrecoverable read error

where isolation is uncertain and

failure could be due to a faulty tape

cartridge or to faulty drive hardware.

If Flag 4 is also set, the cartridge is

defective. Replace the tape

cartridge.

6 Write failure Set for any unrecoverable write or

positioning error where isolation is

uncertain and failure could be due to

a faulty tape cartridge or to faulty

drive hardware.

If Flag Number 9 is also set, make

sure that the write-protect switch is

set so that data can be written to

the tape (see “Write-Protect Switch”

on page 6-5)). If Flag Number 4 is

also set, the cartridge is defective.

Replace the tape cartridge.

7 Media life Set when the tape cartridge reaches its

end of life (EOL).

1. Copy the data to another tape

cartridge. .

2. Discard the old (EOL) tape.

8 Not data grade Set when the cartridge is not

data-grade. Any data that you write

to the tape is at risk.

Replace the tape with a data-grade

tape.

9 Write protect Set when the tape drive detects that

the tape cartridge is write-protected.

Ensure that the cartridge’s

write-protect switch is set so that

the tape drive can write data to the

tape (see “Write-Protect Switch” on

page 6-5).

10 No removal Set when the tape drive receives an

UNLOAD command after the server

prevented the tape cartridge from

being removed.

Refer to the documentation for your

server’s operating system.

11 Cleaning media Set when you load a cleaning

cartridge into the drive.

No action required.

12 Unsupported format Set when you load an unsupported

cartridge type into the drive or when

the cartridge format has been

corrupted.

Use a supported tape cartridge.

15 Cartridge memory chip

failure

Set when a cartridge memory (CM)

failure is detected on the loaded tape

cartridge.

Replace the tape cartridge.

16 Forced eject Set when you manually unload the

tape cartridge while the drive was

reading or writing.

No action required.

17 Media loaded is

Read-only format

Set when a cartridge marked as read

only is loaded into the drive. The flag

is cleared when the cartridge is

ejected.

No action required.

Appendix B. TapeAlert Flags B-3

1 2 ... 216 217 218 219 220 221 222 223 224 225 226 ... 263 264

Kommentare zu diesen Handbüchern

Keine Kommentare

Dell TL2000 Bedienungsanleitung Seite 221

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computerzubehör Dell TL2000