Dell TL2000 Bedienungsanleitung PDF herunterladen (Seite 73)

backup and recovery. These settings are required for Library Managed

Encryption only. Enter the EKM Server Setting information.

v Primary IP address (IPv4 or IPv6): Enter the IP address of the primary EKM

server.

v Primary TCP port: After entering the Primary IP address, the library will

automatically set the value of the Primary TCP port.

v Secondary IP address (IPv4 or IPv6): Enter the IP address of the secondary

EKM server.

v Secondary TCP port: After entering the Secondary IP address, the library

will automatically set the value of the Secondary TCP port.

Note:

The Default Port for TCP (SSL disabled) is 3801. The Default Port for

SSL is 443. These values are the default values set by the library. They

can be changed depending on the user configuration but the user has

to make sure they match the EKM properties file.

Note: If SSL is enabled the encryption host configuration will request a SSL

port instead of a TCP port. Review your Dell PowerVault Encryption

Key Manager User’s Guide for instructions to locate the appropriate port

settings.

Click Activate to apply the changes.

9. Install the Dell Encryption Key Manager (EKM) application on your host. Refer

to the Dell EKM documentation provided with your Encryption packet. The

EKM IP address and EKM port will be provided to the user by the EKM

application.

Choosing Drive(s) Interface Identification/Settings

1. Click Drives in the left navigation pane.

2. Select the desired settings for each drive listed (either SCSI, SAS, or Fibre

Channel). See Figure 4-26.

3. Click one of the following:

v Refresh - to update the current screen

v Submit - to apply the changes made to the screen

a77ug095

Figure 4-26. The Configure Library: Drive screen

Chapter 4. Installation and Configuration 4-23

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 263 264

Keine Kommentare

Dell TL2000 Bedienungsanleitung Seite 73