Dell TL2000 Bedienungsanleitung PDF herunterladen (Seite 241)

5. Add the /LUNS switch to the load line of the appropriate SCSI driver. If a dual

channel card is installed and the user is unsure which channel the LUN device

is attached to, simply edit both lines.

LOAD ADPT160M.HAM SLOT=201 /LUNS

LOAD ADPT160M.HAM SLOT=202 /LUNS

6. After the STARTUP.NCF file has been edited, save the file and reboot the server

to activate the new STARTUP.NCF.

7. Upon reboot navigate to the System Console and type scan all. This will start

a scan of all the LUNS on each adapter.

8. When the scan is complete, verify the LUN device has been detected using the

list storage adapters command. Typical output with both the tape drive and

loader being recognized:

0x08 [V321-A3] Adaptec SCSI Card 39160/3960D - Ultra160 SCSI [slot 201]

0x16 [V321-A3-D5:1] DELL PV-124T 0031

0x15 [V321-A3-D5:0] IBM ULTRIUM-TD3 5BG2

0x09 [V321-A4] Adaptec SCSI Card 39160/3960D - Ultra160 SCSI [slot 202]

Netware may display unbound device, meaning a driver is not bound to the

loader unless a driver from a backup software is loaded. This does not prevent

the backup application from detecting the LUN and binding the appropriate

driver.

Note:

The user must type the command scan all upon OS boot every time. If

backup software services automatically start on OS boot, the user must

disable them, run the scan all command, and re-enable the services.

Appendix D. Enabling LUN Support in Linux D-3

1 2 ... 236 237 238 239 240 241 242 243 244 245 246 ... 263 264

Keine Kommentare

Dell TL2000 Bedienungsanleitung Seite 241