Dell TL2000 Bedienungsanleitung Seite 195
- Seite / 264
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
screen entitled “VPD Selection”, where it is asking you to determine which copy of
VPD should be written to the new Library Controller Card.
If the message ″VPD Selection″ is displayed at the Operator Control Panel,
carefully highlight the “VPD from Enclosure″ option to copy that version of the
VPD to the new Library Controller Card. Then continue with the procedure.
Removal and Replacement
1. Power OFF the library by pressing and holding the power button at the front
of the library for 4 seconds.
2. Disconnect the power cord from the electrical source, then from the power
supply or supplies at the back of the library.
3. Loosen the two blue captive thumbscrews on the Library Controller Card.
4. Grasp the two thumbscrews and pull the defective Library Controller Card
out of the library.
5. Remove the packaging from the replacement Library Controller Card.
6. Grasp the two thumbscrews and push the replacement Library Controller
Card into the library.
7. Tighten the two blue captive thumbscrews on the Library Controller Card.
8. Connect the power cord to the power supply or supplies at the back of the
library, then to the electrical source.
9. Power ON the library using the power button on the front panel.
10. After power is restored to the Library Controller Card, the library will
automatically restore the VPD on the new Library Controller Card from the
Library Enclosure. If a ″VPD Selection″ message is displayed in the Operator
Control Panel, see the ″Read Me before Continuing″ section earlier in this
procedure to determine how to respond to the message.
11. Upgrade library firmware and drive firmware to the latest version. See
“Service Library: Upgrade Firmware” on page 5-54.
12. Run the Library Verify test (refer to “Service: Library Verify” on page 5-26).
a66mi097
Figure 10-10. A Library Controller Card being removed from the library
Chapter 10. Check, Adjust, Remove, and Replace 10-9
- User’s Guide 1
- Read this First 5
- Contents 7
- Figures 9
- Danger Notice 13
- Caution Notice 13
- Class I Laser Product 14
- Rack Safety 15
- Preface 17
- Front Panel 19
- Rear Panel 21
- Internal View of Library 23
- Bar Code Reader 24
- Encryption 24
- SNMP Messaging 26
- Ultrium Tape Drives 27
- Speed Matching 28
- Channel Calibration 28
- Power Management 29
- Library Specifications 29
- Operation Specifications 30
- Environmental Specifications 30
- Product Environment 31
- Supported Device Drivers 31
- Operator Control Panel 33
- Power-ON Display 34
- Input Modes 35
- Power ON/OFF 36
- Web User Interface 36
- System Status 38
- Basic Guidelines 41
- Library Sharing 41
- Host Interfaces 46
- SCSI Interface 46
- Using Multiple SCSI Buses 47
- SAS Interface 48
- Fibre Channel Interface 48
- Cables and Speeds 49
- Installing Your Library 51
- Choosing a Location 51
- Unpacking the Library 52
- Verifying the Shipment 52
- 2. Store the lock ( 55
- ) and label ( 55
- Figure 4-5 on page 4-6 55
- Connecting a Power Cord 63
- Configuring Your Library 64
- Verifying/Updating Firmware 67
- Setting Up Encryption 71
- Interface 77
- Configuration 78
- Preparing the Host 79
- Verifying the Connection 79
- Cartridge Magazines 80
- 2U Library I/O Station 81
- 4U Library I/O Station 82
- Chapter 5. Operations 87
- Chapter 5. Operations 5-3 89
- Chapter 5. Operations 5-5 91
- Chapter 5. Operations 5-7 93
- Chapter 5. Operations 5-9 95
- Monitor Menu 97
- Monitor: Drive 99
- Monitor: Inventory 101
- Control Menu 102
- Control: Move Cartridges 103
- Control: Magazine 103
- Configure Menu 104
- Chapter 5. Operations 5-19 105
- Configure: Library 106
- Chapter 5. Operations 5-21 107
- Configure: Drive 108
- Configure: Network 109
- Configure: Set Access PIN 110
- Chapter 5. Operations 5-25 111
- Service Menu 112
- Service: Run Tests 113
- Service: Service (Drives) 113
- Drive Tests 114
- Clean Drive 114
- Drive Power 114
- Web User Interface Menus 115
- Monitor Library Menu 116
- Chapter 5. Operations 5-31 117
- Chapter 5. Operations 5-33 119
- Chapter 5. Operations 5-35 121
- Drive Inventory 123
- Magazine Inventory 123
- Configure Library Menu 124
- Chapter 5. Operations 5-39 125
- Chapter 5. Operations 5-41 127
- Configure Library: Drives 129
- Configure Library: Network 130
- Chapter 5. Operations 5-45 131
- Chapter 5. Operations 5-47 133
- Manage Library Menu 135
- Service Library Menu 136
- View Logs 137
- View Drive Logs 137
- Save Drive Dump 138
- Chapter 5. Operations 5-53 139
- Service Library: Reboot 141
- Import Media 141
- Export Media 142
- Dedicated Cleaning Slot 143
- Reserving Slots 143
- Data Cartridges 145
- Cartridge Compatibility 146
- WORM Media 147
- WORM Media Errors 147
- Cleaning Cartridge 147
- Bar Code Label 148
- Write-Protect Switch 149
- Handling the Cartridges 150
- Provide Training 150
- Ensure Proper Packaging 150
- Chapter 7. Troubleshooting 155
- Maintenance Problems 156
- Problem 165
- Chapter 8. Error Codes 169
- Tools Required 187
- Electrostatic Discharge 187
- Relocating Your Library 187
- 1 SCSI cable 190
- 2U Library 4U Library 193
- Swapping Power Supplies 208
- Enclosure 211
- Mixing of Drives 215
- SCSI Element Addressing 217
- Appendix C. Sense Data 225
- 30h 07h Cleaning failure 226
- Drive Sense Data 230
- Red Hat Enterprise Linux 240
- 2003/XP and 2008/Vista 243
- Windows 2008/Vista 244
- Notices 247
- Glossary 249
- Numbers 249
- Glossary H-3 251
- Glossary H-5 253
- Glossary H-7 255
- Glossary H-9 257
- Printed in USA 264
Verwandte Produkte und Handbücher für Computerzubehör Dell TL2000
Computerzubehör Dell 5316M Bedienungsanleitung
(15 Seiten)
(15 Seiten)
(268 Seiten)
(330 Seiten)
(32 Seiten)
(178 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 1.585 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern