Dell PowerConnect W Clearpass 100 Software Betriebsanweisung PDF herunterladen (Seite 31)

The configure terminal command allows you to enter the basic configuration mode and the command prompt is

displayed as follows:

(Instant Access Point)(config)#

The Instant CLI allows CLI scripting in several other sub-command modes to allow the users to configure individual

interfaces, SSIDs, access rules, and security settings.

You can use the question mark (?) to view the commands available in a privileged mode, configuration mode, or sub-

mode.

Although automatic completion is supported for some commands such as configure terminal, the

complete exit and end commands must be entered at command prompt.

Applying Configuration Changes

Each command processed by the Virtual Controller is applied on all the slaves in a cluster. The changes configured

in a CLI session are saved in the CLI context. The CLI does not support the configuration data exceeding the 4K

buffer size in a CLI session; therefore, Alcatel-Lucent recommends that you configure fewer changes at a time and

apply the changes at regular intervals.

To apply changes at regular intervals, use the following command in the privileged mode:

(Instant Access Point)# commit apply

To view the changes that are yet to be applied, use the following command in the privileged mode:

(Instant Access Point)# show uncommitted-config

To revert to the earlier configuration, use the following command in the privileged mode.

(Instant Access Point)# commit revert

Example:

(Instant Access Point)(config)# rf dot11a-radio-profile

(Instant Access Point)(RF dot11a Radio Profile)# beacon-interval 200

(Instant Access Point)(RF dot11a Radio Profile)# no legacy-mode

(Instant Access Point)(RF dot11a Radio Profile)# dot11h

(Instant Access Point)(RF dot11a Radio Profile)# interference-immunity 3

(Instant Access Point)(RF dot11a Radio Profile)# csa-count 2

(Instant Access Point)(RF dot11a Radio Profile)# spectrum-monitor

(Instant Access Point)(RF dot11a Radio Profile)# end

(Instant Access Point)# show uncommitted-config

rf dot11a-radio-profile

no legacy-mode

beacon-interval 200

no dot11h

interference-immunity 3

csa-count 1

no spectrum-monitor

Instant Access Point# commit apply

Using Sequence Sensitive Commands

The Instant CLI does not support positioning or precedence of sequence-sensitive commands. Therefore, Alcatel-

Lucentrecommends that you remove the existing configuration before adding or modifying the configuration details

for sequence-sensitive commands. You can either delete an existing profile or remove a specific configuration by

using the no… commands.

The following table lists the sequence-sensitive commands and the corresponding no command to remove the

configuration.

AOS-W Instant 6.2.1.0-3.3| User Guide Initial Configuration | 31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 295 296

Kommentare zu diesen Handbüchern

Keine Kommentare

Dell PowerConnect W Clearpass 100 Software Betriebsanweisung Seite 31

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Dell PowerConnect W Clearpass 100 Software