
(Instant Access Point)(DHCP Profile<profile-name>)# option <type> <value>
(Instant Access Point)(DHCP Profile<profile-name>)# end
(Instant Access Point))# commit apply
Configuring Local, Local,L3, and Centralized,L2 DHCP Scopes
You can configure Local, Local,L3, and Centralized,L2 DHCP scopes by using the Instant UI or CLI.
In the Instant UI
To configure Local, Local,L3, and Centralized,L2 DHCP scopes:
1. Click More>DHCP Server at the top right corner of the Instant Main window. The DHCP Server window is
displayed.
2. To configure a Local, Local,L3, or Centralized,L2 DHCP scopes, click New under Other DHCP Scopes. The
New DHCP Scope window is displayed. The following figure shows the contents of the New DHCP Scope
window.
Figure 72 New DHCP Scope: Other DHCP scopes
3. Based on type of DHCP scope, configure the following parameters:
Name Description
Name
Enter a name for the DHCP scope.
Type
Select any of the following options:
l Local— On selecting Local, the DHCP server for local branch network is used for
keeping the scope of the subnet local to the OAW-IAP. In the NAT mode, the traffic
is forwarded through the IPSec tunnel or the uplink.
l Local, L3—On selecting Local, L3, the Virtual Controller acts as a DHCP server and
gateway. In this mode, the an OAW-IAP routes the packets sent by clients and also
adds a route on the switch, after the VPN tunnel is set up during the registration of
the subnet.
l Centralized, L2— On selecting Centralized, L2, the Virtual Controller does not
assign an IP address to the client and the DHCP traffic is directly forwarded to the
switch over the IPSec tunnel. The client IP address is obtained from either the
controller or a DHCP server behind the controller serving the VLAN of the client.
VLAN ID Specify a VLANID. To use this subnet, ensure that the VLANID specified here is
assigned to an SSID profile. For more information on SSID profile configuration, see
Configuring VLAN Settings for a WLAN SSID Profile on page 83 and Configuring
VLAN for a Wired Profile on page 110
Table 43:
DHCP Mode: Configuration Parameters
AOS-W Instant 6.2.1.0-3.3| User Guide DHCP Configuration | 217
Kommentare zu diesen Handbüchern