Dell PowerVault NX1950 Bedienungsanleitung PDF herunterladen (Seite 28)

28 Detailed End-to-End iSCSI Setup

Add the newly-created highly available iSCSI instances as a resource

group. The newly-created highly available iSCSI instances are then listed

Active Resources

of cluster nodes.

When you configure the Initiators, add the highly available iSCSI instance

IP address in the

Target Porta ls

tab.

After you complete the setup, the iSCSI Targets created on individual

nodes that have highly available iSCSI instances. If the node fails, the

iSCSI Targets of the failed node are managed by surviving node or the

node that owns the Cluster Group.

Configuring iSCSI Devices

This section provides detailed information about installing and configuring

the Initiator and Target in PowerVault NX1950 storage solution.

Installing Microsoft iSCSI Initiator

The Microsoft iSCSI Initiator is a free download on the Microsoft website at

www.microsoft.com. Different versions of the iSCSI Initiator for x86 (32-bit

processors), x64 (AMD64™ and Intel

EM64T processors), and IA64 (for

Intel processors) are available. For all procedures in this document, go to the

Dell PowerVault NX1950 Systems Support Matrix and verify the iSCSI

Initiator Version that is used on all hosts. Download and extract the

supported iSCSI Initiator software version on the client/server that is used as

an Initiator device.

NOTE: Other versions of iSCSI Initiator are not supported. If you are running a

different version of iSCSI Initiator on the Initiator Clients/Servers, remove the iSCSI

Initiator using the Add/Remove Programs option and install the supported version.

After you download the iSCSI Initiator from the Microsoft website at

www.microsoft.com

, double-click the

Initiator-<version>.exe

(where

version

is the version of the iSCSI Initiator that you downloaded)

file to begin installation.

The

Software Update Installation Wizar

d appears. Click

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 69 70

Keine Kommentare

Dell PowerVault NX1950 Bedienungsanleitung Seite 28