Dell PowerVault NX1950 Bedienungsanleitung PDF herunterladen (Seite 37)

Detailed End-to-End iSCSI Setup 37

To configure the iSCSI HA instance perform the following steps in all

nodes of cluster system:

NOTE: To perform this procedure, you must have Administrator rights on

the local computer. For best practices, use the Run option to perform this

procedure.

Open the

PowerVault NX1950 Management Console

, right-click

Microsoft iSCSI Software Target

, and then click

Create HA Instance

for iSCSI

In the

Create Highly Available Instance for iSCSI Storage

dialog box,

click

Add

In the

Add IP Address Resource

section, choose the following options:

•

Resource name

—Retain the default value or enter a different

name

•

IP address

—IP address to be used by iSCSI initiators to connect

to the iSCSI Target

•

Subnet mask

—subnet mask to be used by iSCSI initiators to

connect to the iSCSI Target

•

Network interface

—select the name of the network interface to

be used for the IP address resource of the cluster resource group.

Click

and add IP address for the second NIC if you have

redundant iSCSI NIC. Click

again.

NOTE: Before you create iSCSI Virtual Disks, create few Dell|EMC LUNs or

PowerVault MD3000 LUNs and assign them to the Cluster's highly-available

Sever (iSCSI HA instance) using PowerVault NX1950 Management console.

If you prefer to use the existing volume of Cluster, then move the volume to

iSCSI HA instances using Cluster Administrator. From any PowerVault NX1950

cluster node, go to Start→ All programs→ Administrative Tools→ Cluster

Administrator.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 69 70

Kommentare zu diesen Handbüchern

Keine Kommentare

Dell PowerVault NX1950 Bedienungsanleitung Seite 37

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computerhardware Dell PowerVault NX1950