Dell PowerVault NX1950 Bedienungsanleitung PDF herunterladen (Seite 38)

38 Detailed End-to-End iSCSI Setup

Perform the following steps to create iSCSI Targets:

Figure 3-4. Creating iSCSI Targets

NOTE: In the PowerVault NX1950 Management Console, right-click Microsoft

iSCSI Software Target, and select Properties. In the Networks tab, select the

corresponding iSCSI NIC IP address and deselect the remaining IP addresses.

If you are using the 3.1 iSCSI Target, select the highly available iSCSI instance

IP address only.

In the

PowerVault NX1950 Management Console

, right-click

iSCSI

Ta rg et s

on the left pane to launch the

Create iSCSI Target Wizard

The

Welcome to the Create iSCSI Target Wizard

screen appears.

Click

The

iSCSI Target identification

screen appears. Enter the

Ta rg et

name

and

Description

. You can use the

Browse

option to view and

choose the servers/clients in the network.

The

iSCSI initiators identifiers

screen appears.

You must associate each iSCSI Target with an iSCSI Initiator.

The iSCSI Initiator is the host that requests access to the storage that

is represented by the iSCSI Target name.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 69 70

Keine Kommentare

Dell PowerVault NX1950 Bedienungsanleitung Seite 38