Dell QLA2200 Installationsanleitung PDF herunterladen (Seite 18)

2-6

EMC Fibre Channel with QLogic HBAs in the Linux x86 Environment

Installing and Configuring the HBA and Driver

Configuring the BIOS Settings

After the HBA is installed, follow these steps to verify and configure

HBA firmware settings.

Refer to the EMC Support Matrix for required BIOS versions for qualified

HBAs.

Ver ifying the

Correct BIOS

Ver sion

You can determine the BIOS version at boot time from the QLogic

banner or from the Fast!Util Options menu.

◆ From the banner — Boot the host and watch for the banner

(shown in the QLA2340 example below, with the ROM BIOS

version highlighted):

• If the banner displays the required version, continue to

Configuring the Host with the QLogic HBA Driver on page 2-12.

• If the banner does not display the required version, upgrade

the firmware as described under Upgrading the HBA BIOS

Using the NVRAM File on page 2-8; then proceed to

Configuring the Host with the QLogic HBA Driver on page 2-12.

◆ From the QLogic Fast!Util Options menu:

a. Boot the host. As soon as the QLogic banner appears, press

CTRL-Q to enter Fast!Util.

b. Select Configuration Settings from the Fast!Util Options

menu.

c. Select Adapter Settings from the Configuration Settings

menu.

d. Under Adapter Settings, note the BIOS version:

– If the banner displays the required version, continue to

Configuring the Host with the QLogic HBA Driver on

page 2-12.

– If the banner does not display the required version,

upgrade the firmware as described under Upgrading the

HBA BIOS Using the NVRAM File; then proceed to

Configuring the Host with the QLogic HBA Driver.

Qlogic Corporation

QLA2312 PCI Fibre Channel ROM BIOS Version 1.42

Press <CTRL - Q> for Fast!UTIL

www.qlogic.com

QLogic_Linux.book Page 6 Monday, November 1, 2004 2:15 PM

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 81 82

Keine Kommentare

Dell QLA2200 Installationsanleitung Seite 18