Dell S4810-ON Installationsanleitung PDF herunterladen (Seite 37)

Waste Electrical and Electronic Equipment (WEEE) Directive for Recovery, Recycle and

Reuse of IT and Telecommunications Products

Dell Networking switches are labeled in accordance with European Directive 2002/96/EC concerning

waste electrical and electronic equipment (WEEE). The Directive determines the framework for the return

and recycling of used appliances as applicable throughout the European Union. This label is applied to

various products to indicate that the product is not to be thrown away, but rather reclaimed upon end of

life per this Directive.

Figure 14. The European WEEE Symbol

In accordance with the European WEEE Directive, electrical and electronic equipment (EEE) is to be

collected separately and to be reused, recycled, or recovered at end of life. Users of EEE with the WEEE

marking per Annex IV of the WEEE Directive, as shown above, must not dispose of end of life EEE as

unsorted municipal waste, but use the collection framework available to customers for the return,

recycling and recovery of WEEE. Customer participation is important to minimize any potential effects of

EEE on the environment and human health due to the potential presence of hazardous substances in

EEE.

Dell Networking products, which fall within the scope of the WEEE, are labeled with the crossed-out

wheelie-bin symbol, as shown above, as required by WEEE.

For information on Dell Networking product recycling offerings, see the WEEE Recycling instructions on

iSupport at: https://www.force10networks.com/CSPortal20/Support/WEEEandRecycling.pdf. For more

information, contact the Dell Networking Technical Assistance Center (TAC) (refer to Contacting the

Technical Assistance Center.

Removing the SD Card

To support high security environments, you can remove and re-install the SD card.

Dell Networking recommends removing the SD card only when necessary. Only authorized personnel

should remove the SD card.

CAUTION: Only remove the SD card to support high security operations and after discussions

with Dell Networking Technical Support or your Dell Networking representative.

To open the case and remove the SD card, follow these steps.

1. Remove the small phillips screws that connect the top of the SD card to the body. The screws are

located on the top and the sides of the chassis.

2. Slide the top backwards until its front flange slides free of the faceplate then lift it off.

3. Gently push the SD card to release it from the slot.

Specifications

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

Keine Kommentare

Dell S4810-ON Installationsanleitung Seite 37