Dell DX6000 Bedienungsanleitung PDF herunterladen (Seite 130)

130 Installing System Components

Replacing the Riser 2 Board on the Expansion-Card Bracket

CAUTION: Many repairs may only be done by a certified service technician.

You should only perform troubleshooting and simple repairs as authorized in

your product documentation, or as directed by the online or telephone service

and support team. Damage due to servicing that is not authorized by Dell is not

covered by your warranty. Read and follow the safety instructions that came

with the product.

Place the riser board in the expansion-card bracket so that the four tab

hooks are fully inserted through the tab slots on the riser board. See

Figure 3-24.

Slide the riser board into the tab hooks.

Using a Phillips screwdriver, secure the board with the Phillips screw.

Reinstall expansion-card riser 2. See "Replacing Expansion-Card Riser 2"

on page 127.

Install all expansion cards in the expansion-card slots. See "Installing an

Expansion Card" on page 121.

Close the system. See "Closing the System" on page 83.

Reconnect your system and peripherals to their electrical outlets, and turn

on the system.

System Memory

Your system supports DDR3 registered DIMMs (RDIMMs) or ECC

unbuffered DIMMs (UDIMMs). Single and dual-rank DIMMs can be 1067-

or 1333-MHz, and quad-rank DIMMs can be 1067-MHz.

The system contains 18 memory sockets split into two sets of nine sockets,

one set for each processor. Each nine-socket set is organized into three

channels of three memory sockets per channel. The first socket of each

channel is marked with white release levers.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 197 198

Keine Kommentare

Dell DX6000 Bedienungsanleitung Seite 130