Dell R2 Schnellstart Anleitung PDF herunterladen (Seite 9)

Getting Started Guide 7

NOTE: If you do not have a DHCP server on your network, a local keyboard,

monitor, and a mouse is required to complete your NAS configuration. See

"Configuring Your System Using a Keyboard, Monitor, and Mouse" for more

information.

NOTE: The Windows Firewall is enabled by default. When you access the

remote system, you may experience issues with connectivity.

Configuring Your System For Network Access

If your NAS system is powered on, turn it off.

Connect one end of an Ethernet cable into one of the 10/100/1000

RJ-45 NIC connectors (see Figure 1-1) on the back of your NAS

system.

For more information on the location of system connectors, see your

NAS system’s

User’s Guide

Connect the other end of the Ethernet cable to a functioning Ethernet

jack.

Push the power button to turn on the NAS system.

Verify that the server is connected to the Ethernet by ensuring that the

LED associated with the NIC connector is illuminated. See Figure 1-1.

If the NIC connector’s LED is a steady green color, then the

connection is good. If the NIC connector’s LED is a flashing amber

color, then data is successfully being transferred.

If the LED is not illuminated, check to make sure that each end of the

Ethernet cable is seated properly in the NIC connector and the

Ethernet jack.

The NAS system retrieves the required information to set up network

parameters (the IP address, gateway subnet mask, and DNS server

address) from a DHCP server on the network.

NOTE: It may take several minutes for the NAS system to boot, depending

on your configuration and the amount of storage attached to the system.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 135 136

Keine Kommentare

Dell R2 Schnellstart Anleitung Seite 9