Dell PowerVault DP500 Bedienungsanleitung PDF herunterladen (Seite 32)



Installing the Cooling Shroud



1. Align the hinges on the shroud pivots located on either end of the fan bracket. See Figure3-10.



2. Slowly lower the shroud straight down into the system until the fan connector engages and the latches snap into place.

Fan Brackets



Removing the Fan Bracket



1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.



2. Open the system. See Opening the System.



3. Remove the cooling shroud. See Removing the Cooling Shroud.



4. Remove the SAS controller daughter card. See Removing a SAS Controller Daughter Card



5. Remove the fans from the fan bracket. See Removing a System Fan.



6. Remove the fan bracket from the system:

a. Press down on the release latch on the left side of the fan bracket. See Figure3-11.

If the bracket does not disengage completely, push down slightly on the bracket when releasing the latch.

b. Rotate the left side of the bracket upward, releasing the plastic clip from its slot in the power supply cage.

c. Draw the bracket out of the system.

Figure 3-11. Removing and Installing the Fan Bracket

shroud pivots (2)

cooling shroud

release latch

shroud hinges (2)

fan bracket



CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See

your ProductInformationGuide for complete information about safety precautions, working inside the computer, and protecting against

electrostatic discharge.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 85 86

Keine Kommentare

Dell PowerVault DP500 Bedienungsanleitung Seite 32