Back to Contents Page
Installing System Components
Dell™PowerEdge™800SystemsInstallationandTroubleshootingGuide
Cooling Shroud
System Fans
Power Supply
Expansion Cards
System Memory
Processor
Installing a RAC Card
System Battery
This section describes how to install the following system components:
l Cooling shroud
l System fans
l Power supply
l Memory modules
l Processor
l Expansion cards
l System battery
Cooling Shroud
Removing the Cooling Shroud
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the bezel. See "Removing the Bezel" in "Troubleshooting Your System."
3. Lay the system on its right side.
4. Remove the cover. See "Removing the Cover" in "Troubleshooting Your System."
5. Disconnect the power cables and hard-drive interface cable connectors from the SCSI backplane (if applicable) or hard drives.
6. Press the shroud release tab on the back panel toward the power supply. See Figure6-1.
7. Lift the cooling shroud out of the system. See Figure6-1.
Figure 6-1. Removing the Cooling Shroud
CAUTION: See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.
Kommentare zu diesen Handbüchern