Dell PowerEdge 800 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 16)

System Messages

System messages appear on the screen during system boot to notify you of a possible problem with the system. Table2-7 lists the system messages that can

occur and the probable cause and corrective action for each message.

Table 2-7.SystemMessages

Diskette or hard-drive failure.

Ensure that the diskette drive and hard drive(s) are properly connected. See

"Installing Drives" for information on the drive(s) installed in your system.

Possible USB failure.

See "Troubleshooting a USB Device" in "Troubleshooting Your System."



No memory modules detected.

See "Troubleshooting System Memory" in "Troubleshooting Your System."



System board failure.

See "Getting Help."



Memory configuration error.

See "Troubleshooting System Memory" in "Troubleshooting Your System."



Possible system board resource

and/or system board hardware

failure.

See "IRQ Assignment Conflicts" in "Finding Software Solutions." If the problem

persists, see "Getting Help."



Possible expansion card failure.

See "Troubleshooting Expansion Cards" in "Troubleshooting Your System."

Other failure.

Ensure that the diskette drive, optical drive, and hard drive(s) are properly

connected. See "Troubleshooting Your System" for the appropriate drive(s) installed

in your system.

If the problem persists, see "Getting Help."

The system is in a normal operating

condition after POST.

Information only.

NOTE: If you receive a system message that is not listed in Table2-7, check the documentation for the application that is running when the message

appears or the operating system's documentation for an explanation of the message and recommended action.



Message



Causes



Corrective Actions

Amount of available memory limited to

256MB!

OS Install Mode is enabled

in the System Setup program.

Disable OS Install Mode in the System Setup program. See "Using the System

Setup Program" in your User's Guide.

Attempting to update Remote

Configuration. Please wait....

Remote Configuration is in

progress.

Wait until the process is complete.

BIOS Update Attempt Failed

BIOS remote update failed.

Retry update.

Caution! NVRAM_CLR jumper is installed

on system board.

NVRAM_CLR jumper is

installed.

Remove the NVRAM_CLR jumper. See FigureA-2 for the jumper location.

CD-ROM drive not found

Improperly connected or

missing optical drive.

If no optical drive is installed, disable the IDE controller. See "Using the System

Setup Program" in your User's Guide.

If an optical drive is installed, see "Troubleshooting an Optical Drive" in

"Troubleshooting Your System."

Decreasing available memory

Faulty or improperly installed

memory modules.

Ensure that all memory modules are properly installed. See "Troubleshooting

System Memory" in "Troubleshooting Your System."

Diskette drive 0 seek failure

Incorrect configuration

settings in System Setup

program.

Run the System Setup program to correct the settings. See "Using the System

Setup Program" in your User's Guide.

Faulty or improperly installed

diskette, loose diskette drive

Replace the diskette. Ensure that the diskette drive and optical drive cables

are properly connected. See "Troubleshooting a Diskette Drive" and

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 81 82

Kommentare zu diesen Handbüchern

Keine Kommentare

Dell PowerEdge 800 Anleitung zur Fehlerbehebung Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Server Dell PowerEdge 800