Dell Force10 S60-44T Installationshandbuch PDF herunterladen (Seite 28)

Access the Console Ports | 28

Access the Console Ports

You can access the S60 system directly through the console port at rear of the system (

Figure 6-1

Access the RJ-45 Console Port (RS-232)

NOTE: Before starting this procedure, be sure you have a terminal emulation program already installed on

your PC.

The RS-232 console port is labeled on the upper right-hand side on the rear of the S60 system.

Figure 6-1. S60 Serial Console Port Connector

For the console port pin assignments, refer to

Table 6-1

To access the RJ-45 console port, follow these steps:.

Step Task

1 Install an RJ-45 copper cable into the console port. Use a rollover cable to connect the S60 console port to a

terminal server.

2 Connect the other end of the cable to the DTE terminal server.

3 Set the default terminal settings as follows:

• 9600 baud rate

• No parity

• 8 data bits

•1 stop bit

• No flow control

Console

Port

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 44 45

Keine Kommentare

Dell Force10 S60-44T Installationshandbuch Seite 28