Dell DL1000 Spezifikationen PDF herunterladen (Seite 14)

5. Installing the Core Management Console.

Installation Prerequisites

Network Requirements

The Dell PowerVault DL Backup to Disk Appliance requires the following network environment:

• Active network with available Ethernet cables and connections

• A static IP address and DNS server IP address, if not provided by the Dynamic Host Configuration

Protocol (DHCP)

• User name and password with administrator privileges

Recommended Network Infrastructure

Dell recommends that organizations use a 1 GbE switch along with AppAssure 5 for efficient

performance.

Setting Up The Hardware

The appliance ships with a single DL1000 system. Before setting up the appliance hardware, see the

Getting Started Guide for your DL1000 system that shipped with the appliance. Unpack and set up the DL

Backup to Disk Appliance hardware.

NOTE: The software is pre-installed on the appliance. Any media included with the system must be

used only in the event of a system recovery.

To set up the DL Backup to Disk Appliance hardware:

1. Rack and cable the DL1000 system.

2. Turn on the DL1000 system.

Installing The Appliance In A Rack

If your DL1000 system includes a rail kit, locate the Rack Installation Instructions supplied with the rack

kit. Follow the instructions to install the rails and the DL1000 in the rack.

Using The System Without A Rack

You can use the system without the server rack. When you are using the system without a rack, ensure

that you follow these guidelines:

• The system must be placed on a solid, stable surface that supports the entire system.

NOTE: The system must not be placed vertically.

• Do not place the system on the floor.

• Do not place anything on top of the system. The top panel may deflect under the weight and cause

damage to the system.

• Ensure adequate space around the system for proper ventilation.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 53 54

Keine Kommentare

Dell DL1000 Spezifikationen Seite 14