Dell Vizioncore Betriebsanweisung PDF herunterladen (Seite 65)

vReplicator v2.5 Chapter 3 Configuration 62

Connections Setup

After you define your settings on the First Time Setup dialog, you can add a VC or host,

connect to it, or remove it through the Connection Setup dialog. You can also set a

default VC or host to load automatically upon startup. If you skip the initial configuration

process when you first access vReplicator, you can define these settings later through

Connect on the Menu Bar of the vReplicator window. For instructions on configuring a

VC or host, see Chapter 4.

VirtualCenter(s) Tab

In vReplicator, you must configure each VC that manages source or destination servers.

That is, you must add each VC individually and connect to it.

Default Start Up

Connection

When vReplicator boots, it will automatically attempt to

connect to configured VCs or hosts. vReplicator can only

connect to one at a time—VCs or hosts—not to both

simultaneously. This field indicates the default VC to which

vReplicator will connect.

You will know that the VC default has been set if this

message displays below the field: Load VirtualCenter(s) on

start up.

Configured VC List

(text box)

Each VC that has been configured in this instance of

vReplicator is listed in this text box.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 188 189

Keine Kommentare

Dell Vizioncore Betriebsanweisung Seite 65