Dell PS4100 Installationsanleitung PDF herunterladen (Seite 21)

PS4100 Installation Guide Connecting the Array Cables

Figure 6 Power Supply LEDs

Table 4 Power Supply LED Descriptions

Set Up a Serial Connection to the Array

If you plan to use the setup utility to configure the software, you must set up a serial connection between

the array and a computer. If you plan to use the Remote Setup Wizard, you do not need a serial connection.

See Choose a Configuration Method on page 17 for information about Remote Setup Wizard requirements.

The serial cable shipped with the array is a standard null-modem cable with a female DB9 connector on each

end. You might have to make or buy an adapter cable (one DB9 connector and one RJ45 connector) to

connect the array to some terminal server models. See Serial Cable Pinout Information on page 14 for more

information.

Attach the cable to the serial port on the active control module (ACT LED will be green) and to a console

terminal or a computer running a terminal emulator.

See Figure 7 (not to scale).

Callout Description

1 Power Supply status. This LED is lit (green) when the switch is on and the power supply

is providing power to the array.

2 Error. This LED is lit (amber) if the power supply has a problem.

3 AC Power. This LED is lit (green) as long as mains power is connected to the power

supply.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 48 49

Keine Kommentare

Dell PS4100 Installationsanleitung Seite 21