Dell PowerVault DP500 Bedienungsanleitung PDF herunterladen (Seite 9)

Introduction 9

Pre-Requisites

Before you set up the iSCSI Target, ensure that you perform the following

steps:

Download the Microsoft iSCSI Initiator software from the Microsoft

Support website at

support.microsoft.com

and install the Initiator (Host).

Turn on the PowerVault 500/PowerVault 600 storage system. Create one

or more volumes on the internal hard drives and use them for creating

Virtual Disks for iSCSI Targets.

On the iSCSI Target, right-click

Microsoft iSCSI Software Target

and

click

Properties

. If the system is configured with multiple NICs, select the

NICs that are being used for iSCSI traffic in the

Network

tab and click

Configuring the Initiator (Host)

Configure the Microsoft iSCSI Initiator with the IP address of the Target

server. Perform the following steps to configure the Initiator:

Go to the server that has Microsoft iSCSI Initiator installed. Select

Start

→

Programs

→

Microsoft iSCSI Initiator

→

iSCSI Initiator Properties

→

Discovery

tab

→

select

Add

Add the IP address of one of the NICs on the PowerVault 500/PowerVault 600

storage system that is configured for iSCSI traffic.

Click

Advanced

and select the following options:

–

Local Adapter

—

Microsoft iSCSI Initiator

–

Source IP

—IP address of the host that is being used for iSCSI

Click

and click

again.

NOTE: It is recommended that you configure dedicated iSCSI NICs on separate

subnets on the iSCSI network and not on the public network.

Setting Up the PowerVault 500/PowerVault 600 Storage System as

Target

Creating the Target

Click

Programs

→

Administrative Tools

→

Microsoft iSCSI Software

Ta rg et

to open the

Microsoft iSCSI Software Target

console.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Dell PowerVault DP500 Bedienungsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computerhardware Dell PowerVault DP500