
Introduction 13
3
In
Advanced Settings
window, select
General
tab, and select the following
options from drop-down menu and click
OK
.
– Local adapter—Microsoft iSCSI Initiator
– Source IP—One of the host IP addresses
– Target Portal—iSCSI IP address of the PowerVault 500/PowerVault
600 storage system
4
In the
Log On to Target
window, click
OK
.
The
Ta rg et s
tab displays the status of Target as
Connected
.
5
To accomplish Multipathing, you can establish multiple sessions from the
host to the same Target device using Microsoft MPIO. To enable multiple
sessions:
a
Go to the
Tar g et s
tab and select the Target that is
Connected
.
b
Perform step 1 to step 3 listed in "Targets Tab" on page 18.
c
In the
Advanced Settings
window, configure the redundant host
IP address and Target Portal as the iSCSI IP address of the
PowerVault 500/PowerVault 600 storage system.
NOTE: You must select the option Microsoft MPIO during iSCSI Initiator
software installation. Multiple connections per session (MC/S) is not
supported on the PowerVault 500/PowerVault 600 storage system.
6
To initialize and configure the iSCSI device as local drive and perform
iSCSI I/O operations, go to
Computer Management
→
Disk Management
option.
Method 2 (Discovery Using iSNS Server)
This section describes the procedure for iSCSI Target discovery using the
iSNS server.
Pre-Requisites
Before you perform iSCSI Target discovery, perform the following steps:
1
Download the Microsoft iSCSI Initiator software from the Microsoft
Support website at
support.microsoft.com
and install the Initiator (Host).
2
Download the Microsoft iSNS Server software from the Microsoft Support
website at
support.microsoft.com
and install a Client/Server running
Windows operating system.
Kommentare zu diesen Handbüchern