Dell PowerVault DP100 Bedienungsanleitung PDF herunterladen (Seite 50)

l POWER CONN connector on the backplane board (if applicable)

l PWR_CONN and 12V connectors on the system board

l Hard drives

l Diskette drive (if applicable)

l Optical drive (if applicable)

l Tape backup drive (if applicable)



4. Remove the cooling shroud. See Removing the Cooling Shroud.



5. Remove the four screws securing the power supply to the back panel. See Figure3-17.

Figure 3-17. Removing the Power Supply



6. Slide the power supply toward the front of the system, and then lift the power supply up and out of the system.



Replacing the Power Supply



1. Lower the power supply into the system and align the mounting holes with the holes on the back panel.



2. Install the four screws securing the power supply to the back panel.



3. Install the cooling shroud. See Installing the Cooling Shroud.



4. Connect the DC power cables to the following components:

l POWER CONN connector on the backplane board (if applicable)

l PWR_CONN and 12V connectors on the system board

l Hard drives or SAS backplane.

l Diskette drive (if applicable)

l Optical drive (if applicable)

l Tape backup drive (if applicable)



5. Close the system. See Closing the System.



6. Stand the system upright.



7. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

power supply

screws (4)

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 87 88

Keine Kommentare

Dell PowerVault DP100 Bedienungsanleitung Seite 50