Dell PowerEdge 700 Bedienungsanleitung PDF herunterladen (Seite 57)

Back to Contents Page



Installing System Options

Dell™PowerEdge™700SystemsInstallationandTroubleshootingGuide

Cooling Shroud

System Fans

Memory Modules

Processor

Expansion Cards

System Battery



This section describes how to remove and install the following components:

l Cooling shroud

l System fans

l Memory modules

l Processor

l Expansion cards

l System battery



Cooling Shroud



The cooling shroud provides cooling for the processor and heat sink.



Removing the Cooling Shroud



1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2. Remove the bezel. See "Removing the Bezel" in "Troubleshooting Your System."

3. Lay the system on its right side.

4. Remove the cover. See "Removing the Cover" in "Troubleshooting Your System."

5. Disconnect the power cables and hard-drive interface cable connectors from the SCSI backplane (if applicable) or hard drives.

6. Press the shroud release tab on the back panel toward the top of the system. See Figure6-1.

7. Gently lift the cooling shroud away from the system board.

Figure 6-1. Removing the Cooling Shroud



CAUTION: See your System Information Guide for complete information about safety precautions working inside the computer and protecting

against electrostatic discharge.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 93 94

Keine Kommentare

Dell PowerEdge 700 Bedienungsanleitung Seite 57