Dell PowerEdge 800 Wartungshandbuch PDF herunterladen (Seite 54)



3. Install the cooling shroud. See "Installing the Cooling Shroud."



4. Connect the DC power cables to the following components:

l POWER CONN connector on the backplane board (if applicable)

l PWR CONN and 12V connectors on the system board

l Hard drives or SCSI backplane.

l Diskette drive (if applicable)

l Optical drive (if applicable)

l Tape backup drive (if applicable)



5. Install the cover. See "Replacing the Cover" in "Troubleshooting Your System."



6. Stand the system upright.



7. Install the bezel. See "Installing the Bezel" in "Troubleshooting Your System."



8. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Expansion Cards

Your system supports up to five full-length expansion cards, installed in connectors on a riser card. The expansion slots are configured as follows:

¡ Slots 1 and 2 are x1 lane-width PCI-Express expansion slots.

¡ Slots 3 and 4 are 3.3-V, 64-bit, 100-MHz PCI-X expansion slots. 133-MHz cards installed in these slots will run at 100 MHz.

¡ Slot 5 is a 5-V, 32-bit, 33-MHz legacy PCI expansion slot.

Figure6-6 shows the relative locations of the expansion-card slots.

Figure 6-6. Expansion Slots



Installing an Expansion Card



1. Unpack the expansion card, and prepare it for installation.

For instructions, see the documentation that accompanied the card.



2. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.



3. Remove the bezel. See "Removing the Bezel" in "Troubleshooting Your System."



4. Lay the system on its right side.

NOTICE: If you install a RAC card, it must be installed in PCI slot SLOT_5.

CAUTION: See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting

against electrostatic discharge.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 86 87

Keine Kommentare

Dell PowerEdge 800 Wartungshandbuch Seite 54