Dell S4810 Spezifikationen

Dell Force10S4810 SystemQuick Start GuideRegulatory Model: S4810P

6 Installing the HardwareSplitting QSFP Ports to SFP+ PortsThe S4810 supports splitting a single 40G QSFP port into four 10G SFP+ ports using one of t

Installing the Hardware 7Dell Force10 recommends re-inspecting your system prior to powering up. Verify that:• The equipment is properly secured to th

8 Installing the Hardwarechassis is powered-up; there is no on/off switch.FansThe S4810 comes from the factory with 1 power supply and 2 fan modules i

Installing the Hardware 9Environmental ParametersAC Power RequirementsDC Power RequirementsPower Consumption 230 Watts (nominal)270 Watts (maximum)Par

10 Installing the HardwarePower SuppliesThe S4810 is designed to support two hot-swappable power supplies with integrated fans that provide the coolin

Installing the Hardware 11DC Power SupplyStep Task1 Take the power supply unit out of the shipping box.2 Using the grab handle, slide the unit into th

12 Installing the Hardware

Installing the Software 132Installing the SoftwareNavigating CLI ModesThe FTOS prompt changes to indicate the CLI mode. You must move linearly through

14 Installing the SoftwareAccessing the RJ-45 Console Port with a DB-9 AdapterYou can connect to the console using an RJ-45 to DB-9 adapter along with

Installing the Software 15To view the interfaces in Layer 2 mode, use the show interfaces switchport command in the EXEC mode.Configure a Host NameThe

16 Installing the SoftwareConfigure a Management RouteDefine a path from the system to the network from which you are accessing the system remotely. M

Installing the Software 17Configure the Enable PasswordAccess the EXEC Privilege mode using the enable command. The EXEC Privilege mode is unrestricte

18 Installing the SoftwareAssign Interfaces to a VLANOnly interfaces in Layer 2 mode can be assigned to a VLAN using the tagged and untagged commands.

Installing the Software 19Assign an IP address to a VLANVLANs are a Layer 2 feature. For two physical interfaces on different VLANs to communicate, yo

20 Installing the Software

www.dell.com | support.dell.comPrinted in the U.S.A.

Dell Force10S4810 SystemQuick Start GuideRegulatory Model: S4810P

Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indic

About this Guide 1About this GuideThis document is intended as a Quick Start Guide to get new systems up and running and ready for configuration. For

2 About this Guide

Installing the Hardware 31Installing the HardwareThis guide assumes all site preparation has been performed before installing the chassis.Installing t

4 Installing the HardwareInstall chassis into 2-post rack or cabinetAttach a Ground CableThe S4810 is shipped with 1 M4x0.7 screw for attaching a grou

Installing the Hardware 5 NOTE: Coat the one-hole lug with an anti-oxidant compound prior to crimping. Bring any un-plated mating surfaces to a shiny