OSPFv3 Commands 741
User Guidelines
This command has no user guidelines.
Example
Use the following command to enable OSPFv3.
console(config)#ipv6 router ospf
maximum-paths
Use the
maximum-paths
command in Router OSPFv3 Configuration mode to set the number of
paths that OSPF can report for a given destination.
Syntax
maximum-paths
maxpaths
no maximum-paths
•
maxpaths
—
Number of paths that can be reported. (Range: 1-2)
Default Configuration
2 is the default value for
maxpaths
.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the number of paths that OSPF can report for a given destination
to 1.
console(config)#ipv6 router ospf
console(config-rtr)#maximum-paths 1
redistribute
Use the
redistribute
command in Router OSPFv3 Configuration mode to configure the OSPFv3
protocol to allow redistribution of routes from the specified source protocol/routers.
Kommentare zu diesen Handbüchern