OSPF Commands 675
OSPF Commands
area default-cost
Use the
area default-cost
command in Router OSPF Configuration mode to configure the
monetary default cost for the stub area. Use the no form of the command to return the cost to the
default value.
Syntax
area
area-id
default-cost
integer
no area
area-id
default-cost
•
area-id
—
Identifies the OSPF stub area to configure. (Range: IP address or decimal from
0-4294967295)
•
integer
—
The default cost for the stub area. (Range: 1-16777215)
Default Configuration
10 is the default configuration for
integer
.
Command Mode
Router OSPF Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example identifies a stub area of 10 and default cost of 100.
console(config)#router ospf
console(config-router)#area 10 default-cost 100
Kommentare zu diesen Handbüchern