Dell PowerVault NX1950 Bedienungsanleitung PDF herunterladen (Seite 9)

Configuring 3.1 Target 9

Upgrading Your Dell PowerVault

NX1950 Integrated and Gateway

Solutions to Enable iSCSI

Active/Active Target

You can use the Microsoft

internet Small Computer System Interface

(iSCSI) Active/Active Target 3.1, to configure Active/Active Targets on your

Dell™ PowerVault™ NX1950 Integrated and Gateway solutions. To upgrade

the iSCSI Active/Active Target 3.1:

Perform the steps in "Planning" on page 10.

Perform the steps in "Uninstalling the Current Target" on page 10.

Perform the steps in "Creating a New Target" on page 12.

Creating a highly available iSCSI instance. For more information about

creating a highly available iSCSI instance, see the

Dell PowerVault NX1950

Systems Deployment Guide

located on the Dell Support website at

support.dell.com

NOTE: The upgrade procedures in this section are applicable to systems running in

a cluster configured with iSCSI Targets and .vhd files in the current active node.

You can also perform these upgrade procedures to upgrade the iSCSI Target on a

stand-alone system.

NOTE: The term 3.0 Target refers to your current configuration of PowerVault NX1950

solution with iSCSI Active/Passive Target 3.0. The term 3.1 Target refers to the

PowerVault NX1950 configuration with Active/Active Target using iSCSI

Active/Active Target 3.1.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Keine Kommentare

Dell PowerVault NX1950 Bedienungsanleitung Seite 9