Dell PowerVault DP600 Bedienungsanleitung PDF herunterladen (Seite 31)

DPM Reinstallation 31

Prerequisite Network Configuration

To install DPM, the following network configuration requirements must be

met. Contact your network administrator if you need assistance meeting

these requirements.

• Your system must be on a network and have a valid IP address.

• Your system must be a member of a domain.

• All users must be logged on as domain users and be a member of the local

administrators group.

To configure your system to meet these requirements, refer to the following

sections in the Dell PowerVault Data Protection Solution Quick Start Guide:

• "Network Configuration"

• "Changing the Computer Name"

• "Joining a Domain and Adding the Domain User to Local Administrator's

Group"

Virtual Disk Configuration for the DPM Storage Pool

The DPM application requires dedicated disk storage to store the replicas

from the protected systems. You must create one or more RAID 5 virtual disks

for this purpose.

Use OMSA to create the virtual disks to be used by DPM. Refer to the

"Configuring Virtual Disks for DPM" section of the PowerVault Data

Protection Solution Storage Expansion Guide.

NOTE: Do not add available or free disks to the DPM Storage pool at this time. That

task will be performed automatically when you run the PowerVault Data Protection

Solution Configuration Wizard after installing the DPM application.

DPM Installation

To install DPM, use the Reinstallation DVD with Multilingual Support -

Microsoft System Center Data Protection Manager 2007 media that shipped

with your system. Installation steps are below.

Log on to the system using a domain user account that is a member of the

local administrators group.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 39 40

Keine Kommentare

Dell PowerVault DP600 Bedienungsanleitung Seite 31