Dell PowerEdge 2800 Bedienungsanleitung PDF herunterladen (Seite 7)

Installing the SCSI Backplane Daughter Card 1-5

Installing the SCSI Backplane Daughter Card

in a PowerEdge 2850 System

Unpack the SCSI backplane board daughter card kit.

Turn off the system, including any attached peripherals, and disconnect the system from

the electrical outlet.

Remove the bezel (if applicable).

Open the system.

Grasp the plastic tab on the back of the control panel cable and pull the cable connector away

from the backplane connector. See Figure 1-2.

NOTE: If you pull on the control panel cable harness, you may damage the harness.

The SCSI backplane daughter card connector and card guide are located in the compartment

below the control panel cable.

Figure 1-2. Installing a SCSI Backplane Daughter Card

SCSI daughter card

SCSI backplane

retention lever

SCSI daughter card guide

retention peg

on card

control panel cable

SCSI daughter card

backplane connector

control-panel connector on backplane

1 2 3 4 5 6 7 8 9 10 11 12 ... 53 54

Keine Kommentare

Dell PowerEdge 2800 Bedienungsanleitung Seite 7