Dell POWEREDGE M1000E Bedienungsanleitung PDF herunterladen (Seite 225)

Web Tools Administrator’s Guide 197

53-1001772-01

Connection redirection

DRAFT: BROCADE CONFIDENTIAL

Connection redirection

Connection redirection allows iSCSI sessions to be evenly distributed across ports on the same

blade. Before the maximum number of connections is reached for any given port, logins are

redirected to the next available port, resulting in an even distribution of sessions. This distribution

occurs only during the first login phase.

Enabling or disabling connection redirection

Use the following procedure to enable or disable connection redirection.

1. Launch the iSCSI Target Gateway Admin module as described on page 188.

2. Select the Connection Redirection tab.

3. Select the check box in the Enable/Disable column to enable connection redirection for the

required slot. Clear the check box to disable connection redirection.

NOTE

Existing connections are not redistributed when iSCSI ports change state from disabled to

enabled or offline to online.

4. Click Apply.

iSCSI Fibre Channel zone configuration

After you have finished setting up the iSCSI target gateway and whenever you later modify the iSCSI

virtual target mappings, you must create an iSCSI Fibre Channel zone to allow the system’s virtual

initiators (logical FC devices that represent iSCSI initiators) to communicate in a zoned FC

environment with the physical devices to which you have mapped the iSCSI virtual targets.

The procedures in this section show you how to create this zone and add it to the fabric’s zone

database.

Note the following:

• If you already have zone configurations defined in your fabric, you are also able to add the zone

that you create here to some or all of these configurations by selecting them from a list.

• If a defined configuration is currently effective in the fabric and you add your iSCSI FC zone to

that configuration, the configuration is automatically re-enabled to include this zone.

NOTE

If you do not have a zoning license or any zoning implemented, you do not need to create one

for iSCSI target gateway service.

The following default zoning conditions apply:

• If default zoning is set to No Access, then creating an iSCSI Fibre Channel zone is mandatory

as there is no way for the devices to talk to each other without one.

1 2 ... 220 221 222 223 224 225 226 227 228 229 230 ... 309 310

Keine Kommentare

Dell POWEREDGE M1000E Bedienungsanleitung Seite 225