Dell POWEREDGE 2950 Bedienungsanleitung PDF herunterladen (Seite 13)

Rack Installation Guide 11

Configuring the Sliding Rail Assemblies

The sliding rail assembly has a rotating mounting bracket at each end of the rail. The position of the

bracket determines whether the rail assembly is used as a RapidRail or a VersaRail. The RapidRail side of

the bracket has a hook and a latch that secure it to the vertical rail. The VersaRail side of the bracket has

three holes and uses screws to attach it to the vertical rail.

NOTE: The rack kit ships with the slide assemblies in the RapidRails configuration.

To change from one type of rail assembly to the other type of rail assembly:

Lift the blue lever on the rotating mounting bracket (see Figure 1-4).

Rotate the bracket and slide it up off of the two shoulder standoffs.

Continue to rotate the bracket 180 degrees until you can set the notches back over the shoulder

standoffs.

Rotate the bracket in the opposite direction until the bracket clicks into place.

Figure 1-4. Changing the Position of the Rotating Mounting Bracket

1 mounting-bracket flange

(RapidRails version shown)

2 rotating bracket 3 release lever

4 shoulder standoffs (2) 5 notches (2)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 111 112

Keine Kommentare

Dell POWEREDGE 2950 Bedienungsanleitung Seite 13