Dell PowerConnect W-AirWave 7.4 Bedienungsanleitung PDF herunterladen (Seite 62)

62 | Configuring AMP Dell PowerConnect W-AirWave 7.4 | User Guide

Configuring Cisco WLSE Rogue Scanning

The AMP Setup > WLSE page allows AirWave to integrate with the Cisco Wireless LAN Solution Engine

(WLSE). AirWave can discover APs and gather rogue scanning data from the Cisco WLSE.

Figure 31 illustrates and itemizes the AirWave settings for communication that is enabled between AirWave and

WLSE.

Figure 31 AMP Setup > WLSE > Add WLSE Page Illustration

Perform the following steps for optional configuration of AirWave for support of Cisco WLSE rogue scanning.

1. To add a Cisco WLSE server to AirWave, navigate to the AMP Setup > WLSE page and select Add.

Complete the fields in this page. Table 35 describes the settings and default values.

2. After you have completed all fields, select Save. AirWave is now configured to gather rogue information from

WLSE rogue scans. As a result of this configuration, any rogues found by WLSE appear on the RAPIDS >

List page.

Table 35 AMP Setup > WLSE Fields and Default Values

Setting Default Description

Hostname/IP Address None Designates the IP address or DNS Hostname for the WLSE server, which must

already be configured on the Cisco WLSE server.

Protocol HTTP Specifies the protocol to be used when polling the WLSE.

Port 1741 Defines the port AirWave uses to communicate with the WLSE server.

Username None Defines the username AirWave uses to communicate with the WLSE server. The

username and password must be configured the same way on the WLSE server

and on AirWave.

The user needs permission to display faults to discover rogues and inventory API

(XML API) to discover manageable APs. As derived from a Cisco limitation, only

credentials with alphanumeric characters (that have only letters and numbers,

not other symbols) allow AirWave to pull the necessary XML APIs.

Password None Defines the password AirWave uses to communicate with the WLSE server. The

username and password must be configured the same way on the WLSE server

and on AirWave.

As derived from a Cisco limitation, only credentials with alphanumeric

characters (that have only letters and numbers, not other symbols) allow

AirWave to pull the necessary XML APIs.

Poll for AP Discovery; Poll for

Rogue Discovery

Yes Sets the method by which AirWave uses WLSE to poll for discovery of new APs

and/or new rogue devices on the network.

Last Contacted None Displays the last time AirWave was able to contact the WLSE server.

Polling Period 10 minutes Determines how frequently AirWave polls WLSE to gather rogue scanning data.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 309 310

Keine Kommentare

Dell PowerConnect W-AirWave 7.4 Bedienungsanleitung Seite 62