Dell PowerConnect W-Airwave 7.1 Bedienungsanleitung PDF herunterladen (Seite 156)

156 | Discovering, Adding, and Managing Devices Dell PowerConnect W AirWave 7.1 | User Guide

above a device table, will take you to the appropriate Management page (APs/Devices > Manage). See

“Configuring and Managing Devices”

on page158 for more information, and detailed procedures.

Auditing Device Configuration

When you have added a newly discovered device successfully to a Group in Monitor mode, the next step is to

verify device configuration status. Determine whether any changes will be applied to that device when you

convert it to Managed read/write mode.

AWMS uses SNMP or Telnet to read a device’s configuration. SNMP is used for Cisco

controllers. Aruba devices

and wired routers and switches use Telnet/SHH to read device configuration. See “Individual Device Support and

Firmware Upgrades” on page16

9 for more details.

Perform these steps to verify the device configuration statu

1. Browse to the APs/De

vices > List page.

2. Locate the device in the list a

nd check the information in the Configuration column.

3. If the device is in Monitor mode, t

he lock symbol appears in the Configuration column, indicating that the

device is locked and will not be configured by AWMS.

4. Verify the additional information in the C

onfiguration column for that device.

 A status of Good indicates that all of the device's current settings match the group policy settings, and that

no changes will be applied when the device is shifted to Manage mode.

 A status of Mismatched indicates that at least one of the device's current configuration settings do not

match the group policy, and will be changed when the device is shifted to Manage mode.

5. If the device configuration is Mi

smatched, click the Mismatched link to go to the APs/Devices > Audit page.

The APs/Devices > Audit page lists detailed information on all existing configuration parameters and settings

for an individual device.

The group configuration settings

are displayed on the right side of the page. If the device is moved from

Monitor to Manage mode, the settings on the right side of the page overwrite the settings on the left. Figure

104 illustrates this page.

Figure 104 AP

s/Devices > Audit Page Illustration

6. Review the list of changes to be applied to the device to determine

whether the changes are appropriate. If

not, you need to change the Group settings or reassign the device to another Group.

Note: After upgrade, the APs/Devices > Audit page, and certain additional pages, show only Mismatched status by default for

non-template devices.

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 333 334

Keine Kommentare

Dell PowerConnect W-Airwave 7.1 Bedienungsanleitung Seite 156