Dell Force10 S4810P Betriebsanweisung PDF herunterladen (Seite 116)

Usage

Information

If you configure a TELNET client to use a specific VRF, then you need not explicitly

specify the same VRF during the TELNET client sessions corresponding to that VRF.

Example

FTOS(conf)#ip telnet vrf vrf1

FTOS(conf)#do telnet 10.10.10.2

FTOS(conf)#no ip telnet vrf vrf1

ip tftp source-interface

Assign an interface’s IP address in outgoing packets for TFTP traffic.

S4810

Syntax

ip tftp source-interface interface

To return to the default setting, use the no ip tftp source-interface

interface command.

Parameters

interface Enter the following keywords and slot/port or number

information:

• For Loopback interfaces, enter the keyword loopback

then a number from zero (0) to 16383.

• For a Port Channel, enter the keyword port-channel

then a number. For the C-Series and S-Series, the range

is 1 to 128.

• For the SONET interfaces, enter the keyword sonet then

slot/port information.

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

• For VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

Defaults The IP address on the system that is closest to the Telnet address is used in the

outgoing packets.

Command

Modes

CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Verison

8.3.19.0

Introduced on the S4820T.

116

Control and Monitoring

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 174 175

Kommentare zu diesen Handbüchern

Keine Kommentare

Dell Force10 S4810P Betriebsanweisung Seite 116

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Dell Force10 S4810P