Dell PowerEdge 750 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 5)



The existing passwords are not disabled (erased) until the system boots with the password jumper plug removed. However, before you assign a new

system and/or setup password, you must install the jumper plug.



6. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

7. Open the system.

8. Install the password jumper plug.



See FigureA-2 to locate the password jumper on the system board.

9. Close the system, reconnect the system to the electrical outlet, and turn on the system.

10. Assign a new system and/or setup password.



To assign a new password using the System Setup program, see "Using the System Setup Program" in your User's Guide.



Back to Contents Page



NOTE: If you assign a new system and/or setup password with the jumper plug still removed, the system disables the new password(s) the next

time it boots.

1 2 3 4 5 6 7 8 9 10 ... 75 76

Keine Kommentare

Dell PowerEdge 750 Anleitung zur Fehlerbehebung Seite 5