Dell DAE2P Einstellungsanleitung PDF herunterladen (Seite 13)

Step 8

Start the Storage System

1. Turn on the power switches for the DPE2 and any DAE power/cooling modules

(if present).

2. Turn on the power switch for each SPS.

3. Be sure any other devices in the cabinet are correctly installed and ready for

powerup, then

a. Plug the power cords into the power outlets in your facility. (Standard EMC

cabinets use two 240-volt ac cables.) Connect each power cable to a different

branch circuit. Both power cords must be connected to the appropriate power supply.

b. Turn on the master switch/circuit breakers for each cabinet/rack power strip.

The storage system may take several minutes to complete powerup. Amber warning

lights will flash during power-on self-test (POST) and then go off.

The front Fault light and the SPS recharge lights commonly stay on for several minutes while

the SPS units fully charge.

If the amber lights on the front or back of the system remain on, make sure the

system is correctly cabled and then refer to the fault code explanations in the EMC

CLARiiON CX300/CX300i 2-Gigabit Disk Processor Enclosure (DPE2) Hardware

Reference. If you cannot determine any reasons for errors, contact your authorized

service provider.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 26 27

Keine Kommentare

Dell DAE2P Einstellungsanleitung Seite 13