Dell Precision PP15L Spezifikationen PDF herunterladen (Seite 13)

For more information about QuickSet, right-click the icon in the taskbar, and click Help.



Microsoft Windows Power Meter

The Windows Power Meter indicates the remaining battery charge. To check the Power Meter, double-click the icon on the taskbar. For more information

about the Power Meter tab, see "Power Management."

If the computer is connected to an electrical outlet, a icon appears.



Charge Gauge

Before you insert a battery, press the status button on the battery charge gauge to illuminate the charge-level lights. Each light represents approximately 20

percent of the total battery charge. For example, if the battery has 80 percent of its charge remaining, four of the lights are on. If no lights appear, the battery

has no charge.



Health Gauge

The battery operating time is largely determined by the number of times it is charged. After hundreds of charge and discharge cycles, batteries lose some

charge capacity, or battery health. To check the battery health, press and hold the status button on the battery charge gauge for at least 3 seconds. If no

lights appear, the battery is in good condition, and more than 80 percent of its original charge capacity remains. Each light represents incremental

degradation. If five lights appear, less than 60 percent of the charge capacity remains, and you should consider replacing the battery. See "Specifications" for

more information about the battery operating time.



Low-Battery Warning

A low-batterywarningoccurswhenthebatterychargeisapproximately90percentdepleted.Thecomputerbeepsonce,indicatingthatminimalbattery

operating time remains. During that time, the speaker beeps periodically. If two batteries are installed, the low-battery warning means that the combined

charge of both batteries is approximately 90 percent depleted. The computer enters hibernate mode when the battery charge is at a critically low level. For

more information about low-battery alarms, see "Power Management."

Charging the Battery

When you connect the computer to an electrical outlet or install a battery while the computer is connected to an electrical outlet, the computer checks the

battery charge and temperature. If necessary, the AC adapter then charges the battery and maintains the battery charge.

If the battery is hot from being used in your computer or being in a hot environment, the battery may not charge when you connect the computer to an

electrical outlet.

The battery is too hot to start charging if the light flashes alternately green and orange. Disconnect the computer from the electrical outlet and allow the

computer and the battery to cool to room temperature. Then connect the computer to an electrical outlet to continue charging the battery.

For more information about resolving problems with a battery, see "Power Problems."

Removing a Battery

The computer is connected to AC power and the battery is charging.

The computer is connected to AC power and the battery is fully charged.

NOTE: When you press and hold the status button on the battery charge gauge for at least 3 seconds, the charge-level lights will first light to display

the current charge status. Then they switch to Health status where they represent incremental degradation when lit.

NOTICE: To avoid losing or corrupting data, save your work immediately after a low-battery warning. Then connect the computer to an electrical outlet.

You can also turn the computer off and install a second battery in the module bay. If the battery runs completely out of power, hibernate mode begins

automatically.

NOTE: WithDell™ExpressCharge™,whenthecomputeristurnedofftheACadapterchargesacompletelydischargedbatteryto80percentinabout1

hour and to 100 percent in approximately 2 hours. Charge time is longer with the computer turned on. You can leave the battery in the computer as long

as you like. The battery’s internal circuitry prevents the battery from overcharging.

CAUTION: Before performing these procedures, disconnect the modem from the telephone wall jack.