Dell 10g Betriebsanweisung PDF herunterladen (Seite 20)

20 Deployment Guide

Configuring and Teaming the Private Network

Before you deploy the cluster, assign a private IP address and host name to each

cluster node. This procedure ensures that the nodes can communicate with each

other through the private interface.

Table 1-7 provides an example of a network configuration for a two-node

cluster.

NOTE: This example assumes all the IP addresses are registered in the hosts file of

all cluster nodes.

NOTE: The two bonded NIC ports for a private network should be on separate PCI

buses. For example, a bonded pair can consist of one on-board NIC and one add-on

NIC card.

Configuring NIC Teaming For Your Private Network Adapters

NOTE: TCP Offload Engine (TOE) functionality of a TOE-capable NIC is not

supported in this solution.

On node 1, identify two network adapters that will be used for NIC teaming.

Connect an Ethernet cable from each selected network adapter to the private

network switch.

If node 1 is configured with Broadcom NICs, go to step 4. If node 1 is

configured with Intel NICs, configure NIC teaming by performing the

following steps:

Right-click

My Computer

and select

Manage

In the

Computer Management

window, select

Device Manager.

Expand the

Network Adapters

tab.

Table 1-7. Network Configuration Example for a Two-Node Cluster

Host Name Type IP Address Registered In

rac1 Public 155.16.170.1 %SystemRoot%\system32\drivers\etc\hosts

rac2 Public 155.16.170.2 %SystemRoot%\system32\drivers\etc\hosts

rac1-vip Virtual 155.16.170.201 %SystemRoot%\system32\drivers\etc\hosts

rac2-vip Virtual 155.16.170.202 %SystemRoot%\system32\drivers\etc\hosts

rac1-priv Private 10.10.10.1 %SystemRoot%\system32\drivers\etc\hosts

rac2-priv Private 10.10.10.2 %SystemRoot%\system32\drivers\etc\hosts

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 77 78

Keine Kommentare

Dell 10g Betriebsanweisung Seite 20